LUYED Super Bright EX Chipsets LED Bulb – W5W 194 168 2825

  By

Got these LED lights to install in my Honda Odyssey for the license plate light. They are very bright with a nice white output. The build quality is very good. I used them to replace the license plate light in my Honda Odyssey. I also used them to replace the courtesy light in the front door. The installation was very straightforward and easy. I had no issue swapping them out for the incandescent bulb. The license plate illumination is very bright at night. The color is pure white with no hint of blue. The light was much brighter than the factory bulb. The fact it comes in a 10 pack makes it a good value.

 

LUYED 1550 Lumens Extremely Bright LED Bulb For Backup Reverse Light – 921 912 W16W 3030

  By

Got these LED lights to install in my Honda Odyssey for the reverse backup light. I tested them first with a 12V source and they were extremely bright with a super white output. The build quality is very good and they use high quality LED chipsets. The installation was very straightforward and easy. I had no issue swapping them out for the incandescent bulb. After installing these LED light, the improvement was immediately noticed when I put the car in reverse. The light was much brighter than the factory bulb. These LED lights are a good choice for converting your regular bulbs.

 

LUYED 2590 Lumens Extremely Bright LED Bulbs For Turn Signal Lights – 7440 7441

  By

Got these LED lights to install in my Honda Odyssey for the front turn signals. The build quality is very good and they use high quality 3030 LED chipsets. I tested them first with a 12V source and they were extremely bright with a nice amber color output. The installation was very easy and had no issue. After the swap to LED, the improvement was immediately noticed as it was much brighter than the factory bulb. LED has a nice clean fast refresh rate. Made the light appearance so much nicer. Highly recommend them.

ANCEL BA101 Professional 12V Automotive Digital Battery Tester (100-2000 CCA)

  By

Got this Ancel BA101 to test my car battery. The unit uses the car’s 12V battery to power itself. All you need to do is connect the positive and negative clamps to the car battery. The tester has 4 buttons on the front, and a backlit LCD display. On the side, there is a mini USB connector used for connecting to a PC to print the test data. You can easily navigate through the menu to test the battery in vehicle, or test the battery if it’s outside the vehicle. The testing takes only about 8 seconds to perform and will display the test result showing the CCA (cold cranking amp), internal load resistance, and the voltage. The bottom of the screen shows an easy to read status for GOOD, or GOOD RECHARGE, or BAD REPLACE. All the information is found in the user guide. The LCD display is also backlit, so it’s very easy to read even at night.

You can also test the cars starting system, and the charging system. When you test these parameters, you will be instructed to start the vehicle and rev the engine to 2500 rpm for 5 seconds. Then the tester will begin the testing. After a few seconds, it will tell you if your starter or alternator is in good working condition.

I was able to test my battery quickly and found that I will need to recharge it before use. The tester is compact and I will leave it in my glove box so if I ever need to test the battery, I will have this tool on hand.