Category: CAR LIGHTING

Got these LED lights to install in my Honda Odyssey for the reverse backup light. I tested them first with a 12V source and they were extremely bright with a super white output. The build quality is very good and they use high quality LED chipsets. The installation was very straightforward and easy. I had no issue swapping them out for the incandescent bulb. After installing these LED light, the improvement was immediately noticed when I put the car in reverse. The light was much brighter than the factory bulb. These LED lights are a good choice for converting your regular bulbs.

Got these LED lights to install in my Honda Odyssey for the front turn signals. The build quality is very good and they use high quality 3030 LED chipsets. I tested them first with a 12V source and they were extremely bright with a nice amber color output. The installation was very easy and had no issue. After the swap to LED, the improvement was immediately noticed as it was much brighter than the factory bulb. LED has a nice clean fast refresh rate. Made the light appearance so much nicer. Highly recommend them.

This LUYED 3156 LED bulb is commonly used in turn signals. First thing to keep in mind is these bulbs being 3156 which is used to replace single filament bulbs in your vehicle. First thing you will notice is the number of LED chips on each bulb. There are 102 SMD LED chip to be exact. There are LED chips all around the entire bulb along with more on the end for a uniform 360 degree light output.

The light output is pure white with no blue or yellow color. The brightness is also one of the best I have seen. They are polarity sensitive so if you plug it in and doesn’t light up, just flip it the other way around. After lighting it up, it does get warm but the extruded aluminum housing will help with the heat dissipation.

I used these LED bulbs to replace my turn signal light and my video review shows how well it turned out. The installation is very easy and all you have to do is unplug the old bulb and install the new LUYED ones. If your vehicle has the fast blinking error after install, just install a load resistor in parallel to factory wiring and that will take care of it. In my Nissan, I didn’t have to so it worked out very well. I really like how the install turned out and these LED bulbs are very good value.

I got these H11 LUYED LED bulbs to replace my halogen fog lights on my Honda Odyssey. I have tried other high power LEDs claiming to have high lumens, but these LUYED ones are truly one of the best. The first thing you will notice when seeing these for the first time is the number of LED chips on the bulb. The have 102 LED chips all around including the front tip of the bulb.

This design gives a very even light output 360 degrees all around. Other brands with only 10 LEDs gives out a spotty light output. The costruction of the LUYED bulbs are very good. The body is made of extruded aluminum to help dissipate heat. The base has a nice rubber gasket to keep moisture out of your fog light housing. The connector is made of plastic similar to the factory bulb.

As you can see in my video review that these LED bulbs perform very well. A definite upgrade to the factory halogen bulb. Also good to know they will last a very long time.