Category: CAR LIGHTING

The ZDATT LED lighting kit is unique in a sense that it comes with interchangeable color lens tube. Most LED lighting kits out on the market is just 5000K – 6000K color temperature to output pure white. By having interchangeable lens, you can now change the color output to either 3000K (amber) or 8000K (light blue).

The entire LED assembly is metal with an integrated cooling fan at the base. The lens is made of glass. There are 4 COB LED chips to provide the 360 degrees light output. There is an external LED driver housed in a metal enclosure. The light is IP65 rated. The installation is simple plug and play which will only take several minutes.

This 60 in LED tailgate light bar uses 180 pieces of LEDs to illuminate the red and white color for the brake/park/turn/reverse. The length is measured to be exactly 60 in. The LEDs are housed in a soft rubber tube that is flexible. Tip: when you first get it, it’s coiled in a roll. If the weather is cold and you need to straighten it, heat it up a bit with a heat gun to soften the plastic. The wiring comes out of the left side of the light bar and goes to a 4 pin flat connector. You can either plug it directly to a trailer hitch connector or cut the connector and hard wire it to the tail light. I found there are 2 reverse wire which was not mentioned in the guide. The red wire is the reverse full bright, and the yellow wire is the reverse half bright. You will want to connect to the red wire for full brightness.

The back of the light bar comes with 3M double sided tape across the entire length which is nice because it will make the install easy and permanent. I tested all the functions of each wire and you can see that in my video. Overall design is clean and sleek. Next step is to install it onto the truck. But I suggest you do the same and test it first to make sure the unit works fine and also to understand the wiring if you need to hardwire it.

This is a 32″ LED light bar from MICTUNING. It’s rated at 180W with 60 X 3W LED chips. The light output is rated at 13200 lumens at 6000k which is pure white. The light bar comes well packaged in bubble wrap and includes all mounting hardware along with the relay wiring harness. There are 8 LEDs on each side with flood light reflectors. The center LEDs have spot light reflectors. The construction of the housing is all aluminum. The front lens is made of polycarbonate. The unit feels solid.

The light bar wiring is bare wire, so you will need to use the included crimp connectors to connect to the relay harness. The relay harness has a 10 A fuse and the output from the relay goes to 2 pairs of wires for you to connect to 2 light bars if you need to. The harness on/off switch is illuminated and has plenty of length for you to run it into your vehicle.

I tried the light at night and the beam pattern is a large spot circle which gives you a bright center spot light. At a 100 feet in total darkness, the light bar was able to illuminate the area without problem. The light bar did not get too hot even after running it for about 30 minutes. Keep in mind, at 32 in, this is a very wide light bar, so it can be either mounted on the roof or on the front bumper.

Got these LED lights to install in my Honda Odyssey for the license plate light. They are very bright with a nice white output. The build quality is very good. I used them to replace the license plate light in my Honda Odyssey. I also used them to replace the courtesy light in the front door. The installation was very straightforward and easy. I had no issue swapping them out for the incandescent bulb. The license plate illumination is very bright at night. The color is pure white with no hint of blue. The light was much brighter than the factory bulb. The fact it comes in a 10 pack makes it a good value.