Dial2Fast is supported by its audience. When you purchase through our links, we earn an affiliate commission from qualifying purchases

BEST 3 Channel Camera Dashcam (Front + Rear + Cabin) VANTRUE N4

Vantrue N4 Features:

• 3 Channel Dashcam: 155° front camera, 165° inside camera & 160° rear camera

• 1440P+1080P+1080P at 30fps, which gives you all-round protection when you’re on the roads

• Super Night Vision: Sony STARVIS CMOS sensor, big F1.4 aperture 6-glass lens

• Automatic exposure for capturing clear video footage

• Inside camera has 4 IR LED lights for recording inside the vehicle at night

• Heat Resistant with Super Capacitor instead of Li-Ion

• Operate in extreme weather: 14°F to 158°F, Ideal for AZ, Fl, TX, or extremely cold areas

• Parking Mode: triggered by the motion or collision detection (Require Hardwire Kit – see link above)

Install Thinkware Radar Module For Energy Saving Parking Mode – U1000 Dashcam

In this video, I will be installing the Thinkware Radar Module. If you use the radar module and set the dashcam’s parking mode to energy saving, the parking mode will last 6X longer. For a 2 channel dashcam such as the U1000, this setup will allow the parking mode to operate up to 2 to 3 days. When an object such as a vehicle is detected, the dashcam will switch from energy saving mode to recording standby mode. If an impact is detected within 30 seconds, the dashcam will save a 20 second video clip. That’s 10 seconds before the impact and 10 seconds after the impact. If no impact is detected within 30 seconds, the dashcam will switch from recording standby mode back to energy saving mode.

Install Thinkware iVOLT BAB-50 Battery Pack For Dashcam Parking Mode

In this video, I will be reviewing and installing the Thnikware iVOLT BAB-50 Battery Pack used as backup power for the Thinkware U1000 parking mode. This battery will extend the parking mode to 16 hours. With this, it will also eliminate the strain of your car battery if you are to hardwire your dashcam direct to the car battery. The BAB-50 uses LiFePo4 battery cells and can operate in extreme condition safely (-10C – 60C). Check out the link above to purchase this battery system.